Mortar Spraying Machine Instructions

Mortar spraying machine is one of the company's main products. In order to meet the needs of new and old customers, the construction instructions of this product are presented to everyone. Please refer to it carefully.

Step 1: Turn on the power, press the button, the screw pump will start working. If the steering is reversed, press the stop button to stop. Adjust the power supply and reverse the beginning to change the steering. If it is in the opposite direction, it will not be discharged.

Step 2: Inject a small amount of water into the inlet of the conveying hose, or pump the water with a screw pump to wet the conveying hose, and then gradually discharge the water in the tube from the outlet. The drainage should be clean and no residual water should remain in the pipe.

Step 3: Tied the air duct and the mortar tube side by side. The row connects the duct to the gun.

Step 4: Put the evenly mixed material into the hopper (can be used with the powder opener).

Step 5: Press the start button and the shotcrete will start. In the work, combined with the adjustment of the air volume, the spray quality can be achieved at a high speed and high efficiency.

Step 6: The adjustable speed screw pump has an output flow rate of 0-8 liters/min. In operation, as long as the reflow is adjusted to the output speed suitable for the construction requirements.

Step 7: The mixing material must be added continuously in the hopper to ensure the continuity of the spraying work. When the spraying work needs to be paused, press the stop button to make the operation more convenient. The following methods can be used for remote control: the electric box The middle knob to the left is the manual control switch.

Step 8: Before the end of the spraying work, after the remaining material in the hopper is sprayed, close the air pump and stop after the completion.

Step 9: Before the end of the spraying work, after the remaining material in the hopper is sprayed, close the air pump and stop after the completion.

Step 10: Inject water into the hopper, press the button to start the pump water cleaning. When the nozzle is out of clear water, press the button to stop, remove the transfer hose and roll up.

As long as you follow the above steps, the mortar spraying machine is still very easy to operate! !